1 Parameters of control board of BH2098-MB10-5KW induction heater Dimension: 219*160*160 (length * width * height) Working voltage: 220V Power range: 3000W-5000W Capacity of inductance: 80 ± 10uH Conversion efficiency >90% Frequency: 20-25kHZ Working temperature: -10 ℃~50 ℃ Working mode: continuous heating Surge protection: ±1500V Distance from induction coil to heater: 15-20mm (the thickness of pressed insulation cotton plus epoxy plate) Coils are wound on the same heater with distance between each section more than 12cm..
2 Instructions for 5.0 KW ultrathin control board assembly 1, There are 3 lights respectively indicating power, work and fault. The “Power” and “Work” are on if the machine is functioning properly and the “Fault” is off. If there is a rundown, the “Power” and “Work” are off and the “Fault” is on. 2, Connect to the 2 post reading “AC 220V” to get access to power. There is no need to distinguish L or N wire. 3, Coils are attached to 2 posts reading “OUT1””OUT2”. Tighten the screw. 4. Set “work if power is on” at Factory Setting to start. A black short-circuited line at the socket of the "soft switch" can control short circuit. You can also start the machine by gently removing the short-circuit line, then attach one end of a connecting lead (two-wire cord with a 2-pin plug at each end) to the socket of the soft switch and the other end to the two contacts of thermostat controller.
3 Instructions and notifications for 5KW electromagnetic heating control board 1, Requirement for the shell: The main control board should be installed inside the shell since the controller carries high pressure and large current electronics are used. Then it is connected to heating coils, power and thermostat controller by insulation wire. This can prevent electric shock even if electric parts are touched. Also, since the board will generate heat, the shell should be designed to be easy for ventilation and thermal dissipation. A DC12 fan is also added to the device. Please secure the fans on two fixed column on the board and plug the fan into FAN12V two-pin socket next to the relay. 2. Coils and other component Since we only provide control boards, so you need to add other components such as heating coils. Choosing coils can vary depending on power. 10㎡ insulation high temperature resistance wire is fit for 5kw control board. Coils are generally circular with capacity of inductance (L) 80±10uH (Measured by Victor’s BICTOR6243 inductometer when coil is wound on the cylinder) Note: circular coils usually wind 23 laps, which can vary depending on the diameter o